[Phono-L] How to Make a Table Model Victor

[Bob]

I saw something almost as bad.  A couple of years ago there was a Victrola 
XVIII on eBay cut down into a table top machine.  Whoever cut it down did a 
very professional job.  I think I even bid on it.  As I recall, it sold for 
a little over $200.
Bob
----- Original Message ----- 
From: "harvey kravitz" <harveykravitz at yahoo.com>
To: "Antique Phonograph List" <phono-l at oldcrank.org>
Sent: Wednesday, February 03, 2010 12:02 AM
Subject: Re: [Phono-L] How to Make a Table Model Victor


> OMG, another machine bites the dust. At least it wasn't a Flat Top 
> Pooley!!!!
> Harvey Kravitz
>
>
>
>
> ________________________________
> From: "bruce78rpm at comcast.net" <bruce78rpm at comcast.net>
> To: Phono-L <Phono-L at oldcrank.org>; Phonolist <Phonolist at yahoogroups.com>
> Sent: Tue, February 2, 2010 6:55:04 PM
> Subject: [Phono-L] How to Make a Table Model Victor
>
>
>
>
>
>
>
>
>
> Get out your Chain Saw !!
>
> http://hartford.craigslist.org/atq/1581209062.html
>
>
>
> __._,_.___
>
> Reply to sender | Reply to group Messages in this topic ( 1 )
> Recent Activity:
>
>
> Visit Your Group Start a New Topic
>
> MARKETPLACE
>
>
>
> Going Green: Your Yahoo! Groups resource for green living
> Yahoo! Groups
> Switch to: Text-Only , Daily Digest • Unsubscribe • Terms of Use
>
>
> .
>
> __,_._,___
> _______________________________________________
> Phono-L mailing list
> http://phono-l.oldcrank.org
>
>
>
> _______________________________________________
> Phono-L mailing list
> http://phono-l.oldcrank.org